Gas fireplace service
Sweep & inspection
Caps & crowns
Flue relining
Masonry repairLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fireplace Services Cost in High Point?
Fireplace services in High Point typically run $89 to $250 for a standard chimney sweep, $395 to $1,100 for a HeatShield flue resurfacing, and $2,400 to $5,800 for a full DuraFlex liner installation, depending on flue length and access. A fireplace inspection usually sits between $99 and $275. Most homes we look at end up in the $150 to $450 range for the first visit, because the first visit is a sweep and a proper look at what the flue is actually doing. Every price is set per job by a free written estimate, so the numbers below are typical ranges for the High Point market, not a quote.
We’re Chimney Sweep High Point, a chimney and venting specialist working across High Point. We sweep, repair, and reline, and we clean dryer vents under the same call. That matters for pricing: one visit that handles the fireplace and the dryer vent usually costs less than two separate contractors driving out. Call (877) 798-3391. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- A standard sweep is $89 to $250. A sweep plus a Level 2 camera inspection is $175 to $425.
- HeatShield resurfacing restores a damaged flue for $395 to $1,100 and can save you the cost of a full reliner.
- A DuraFlex stainless liner for a wood-burning fireplace runs $2,400 to $5,800.
- Dryer vent cleaning is $95 to $210 and is a fire risk most homeowners never think about.
- Estimates are free, and the written estimate sets the final price.
Fireplace Services Cost Breakdown (2026)
The table below shows typical High Point pricing for the fireplace and venting work we handle. Ranges assume a single-story masonry or prefab chimney with standard roof access. Higher pitches, tight attic clearances, and long flue runs move the number toward the top of a range or above it, which is why the written estimate matters more than any table.
| Service | Typical Range | What’s Included |
|---|---|---|
| Standard chimney sweep | $89 – $250 | Flue brush and vacuum sweep, firebox cleaning, basic visual check |
| Sweep + Level 2 inspection (camera) | $175 – $425 | Full sweep plus video scan of the flue, joints, and cap |
| Fireplace inspection only | $99 – $275 | Visual and camera assessment, written findings |
| HeatShield flue resurfacing | $395 – $1,100 | Cracked tile and mortar joints sealed and resurfaced |
| DuraFlex stainless liner installation (wood) | $2,400 – $5,800 | Flexible liner, insulation, top plate, cap |
| Gas appliance liner | $1,500 – $3,200 | Smaller-diameter liner sized for the appliance |
| Chimney cap replacement (Gelco, Famco) | $145 – $450 | Cap sized and fitted to the flue opening |
| Damper or crown repair | $185 – $650 | Damper replacement or crown rebuild |
| Dryer vent cleaning | $95 – $210 | Full vent run cleared from dryer to exterior, airflow checked |
| Dryer vent reroute or new run | $250 – $700 | Smoother, shorter run with proper fittings |
What pushes a price up: a flue that’s been neglected for years and is packed with creosote, a liner that needs a full replacement instead of a resurface, roof pitch that makes access slow, and a chimney boxed in by siding that has to be opened to reach the flue. What pulls it down: a home swept on a regular rhythm, easy ladder access, and a fireplace that gets caught early before the mortar joints go. Gas appliances sit lower on the liner scale simply because the pipe is smaller and the install is shorter. The written estimate is where those variables get settled for your house.
What Affects Fireplace Services Pricing in High Point
A few things move the number on every estimate we put together in High Point. None of them are sales tactics; they’re the physical facts of your fireplace.
- How much creosote is in the flue. A light glaze sweeps out in under an hour. Glazed, hardened creosote from a slow-burning fire takes more time to clear, so a heavily loaded flue can land near the top of the sweep range or above it. A sweep keeps it from ever getting there.
- Whether the flue is tile or clay and how the joints look. Cracked mortar joints mean fire can reach the structure behind the flue. When we scan with a camera and find gaps, HeatShield resurfacing can seal them without pulling the whole liner. That’s the single most cost-effective repair on this list when it fits the damage.
- Wood vs. gas appliance. Wood fireplaces need a full-size stainless liner, which is the $2,400 to $5,800 side of the scale. Gas appliances use a smaller liner and run $1,500 to $3,200. Pricing a gas job as though it were wood is a common way to overpay.
- Roof access and chimney height. The roof pitch and the height of the stack determine how much of the job is setup. A low-slope roof off a one-story house prices very differently from a tall stack on a two-story with a steep pitch.
- Whether the dryer vent gets done the same visit. Pairing dryer vent cleaning with a chimney sweep is the cheapest way to cover both. Dryer vent buildup is a fire hazard most homeowners never check, and it’s a dedicated service for us, not an add-on.
- Sourcing of parts. Caps, covers, and components sourced from Gelco, Famco, Olympia Chimney, and Copperfield fit right the first time. Improvised hardware-store parts cause callbacks and leaks that cost more than doing it correctly.
How to Save on Fireplace Services
The cheapest fireplace service is the one you don’t need because you caught the problem when it was small. A $89 to $250 sweep once a year beats a $2,400 liner replacement, and that’s the honest math behind every recommendation we make.
- Sweep on a schedule. Homes that burn wood often should sweep annually. Regular sweeps keep creosote from glazing and let us spot a cracked joint while HeatShield resurfacing is still an option instead of a reliner.
- Do the dryer vent when the chimney gets swept. One visit, both venting runs handled, and you skip a second trip charge. Dryer lint in a vent is a real fire risk, and clearing it yearly is inexpensive.
- Fix the cap before the water gets in. A $145 to $450 cap replacement from Gelco or Famco stops water from running down the flue and rotting mortar. Water damage is what turns a cheap repair into a structural rebuild.
- Ask for a written estimate before work begins. Upfront pricing on a written estimate keeps the job honest. Estimates are free, so there’s no reason to agree to open-ended work.
- Don’t let a contractor talk you into a full reliner if the flue only needs resurfacing. HeatShield restores a flue’s integrity when the tile is cracked but the structure is sound. Ask which option fits and why.
- Bundle inspection with the sweep. A camera inspection costs less on the same visit than on its own, and it’s the only way to see what’s happening above the damper.
One more thing that saves money over time: choosing a chimney and venting specialist over a general handyman. Trade-grade products like DuraFlex and HeatShield are the brands professional chimney crews rely on, not hardware-store substitutes. Getting the material right the first time means no repeat visits. To set up a free estimate in High Point, call (877) 798-3391. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
What’s Included in a Standard Fireplace Service in High Point?
A standard fireplace service in High Point is a chimney sweep plus a visual check of the firebox and flue, and it runs $89 to $250. We run a brush and a high-power vacuum up the flue so the soot and creosote leave the house instead of settling on your floor. Then we look at the firebox, the damper, the joints, and the top of the stack. If we find something that needs a camera scan, we’ll tell you before we run the camera.
A sweep is not a relining job and it isn’t disguised as one. If the flue is sound, the sweep is all you need. If the camera shows cracked joints or missing mortar, we’ll price HeatShield resurfacing and explain what it does. HeatShield is a repair-grade sealant system that restores the flue’s surface. When the tile is failing but the chimney’s structure is intact, it can seal the cracks without a full DuraFlex reliner. That’s often the difference between a few hundred dollars and a couple thousand.
The dryer vent belongs in the same conversation
Most homes we visit have never had the dryer vent cleaned, and lint buildup in that run is a fire hazard most homeowners never think about. We handle it as a dedicated service, from the dryer to the exterior hood, and check that airflow actually moves. If the run is long, kinked, or made of the wrong material, we’ll quote a reroute so the vent can breathe. It’s the venting-safety half of the business, and it fits neatly into a chimney visit.
What a full reliner involves
When the flue is too damaged to resurface, the fix is a stainless liner. DuraFlex flexible chimney liner systems are what professional chimney specialists install: the liner is sized to the appliance, insulated, and topped with a proper cap. That’s the $2,400 to $5,800 range for wood and $1,500 to $3,200 for gas. We also work with Olympia Chimney and Copperfield components for the surrounding hardware, so the top plate and cap match the liner rather than being pieced together. You’ll see why this matters every time it rains if the cap doesn’t fit.
Is it cheaper to repair or replace a chimney liner in High Point?
Repairing is cheaper when the damage is surface-level. HeatShield resurfacing at $395 to $1,100 fixes cracked tile and grout when the flue’s structure is still sound. Replacing the liner at $2,400 to $5,800 is the answer when the tile has broken away, the flue is the wrong size, or the chimney has no liner at all. The only way to know which one you’re looking at is a camera inspection, which is why we don’t quote a liner over the phone. Book an inspection and we’ll show you what the flue looks like rather than guess.
Do I need a chimney sweep before I use my fireplace in High Point?
Yes, if it’s been more than a year since the last sweep, or if the fire has been burning slow and smoky. Creosote builds up faster in a wood-burning fireplace used heavily, and a load of it is what feeds a chimney fire. A $89 to $250 sweep clears it and lets us check the damper, the cap, and the flue joints while we’re there. It’s the least expensive service we offer and it’s the one that protects everything else.
Can you clean my dryer vent at the same time as the chimney?
Yes, and it’s the more efficient way to handle both. When we’re in the home for a $89 to $250 chimney sweep, adding dryer vent cleaning at $95 to $210 covers two venting systems in one visit. Dryer lint in a clogged vent is a fire risk most homeowners overlook, and a vent cleaning checks for crushed or plastic runs that need to be replaced. Call (877) 798-3391 for a combined estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
How long does a fireplace service take in High Point?
A standard sweep takes about an hour to ninety minutes. HeatShield resurfacing takes most of a day because the sealant has to cure, and a full DuraFlex liner installation runs a full day or longer depending on chimney height and roof access. Dryer vent cleaning is usually done in under an hour. These aren’t padded times. The trench-and-cure steps on a reliner are what take the hours, and doing them faster is how jobs fail.
Fireplace Safety and When to Call a Technician
We’re careful about telling you what to attempt yourself, and we’d rather be blunt than polite on this point. Creosote and a hot flue are a genuinely dangerous pair, and a chimney fire isn’t the kind of thing you want to discover from the roof. Gas fireplace lines are gas, and the only safe move there is to leave them to a licensed professional. We don’t walk homeowners through pulling a flue brush themselves, and we won’t. A trained technician with a camera does the inspection, finds the cracks, and knows what to seal and what to replace.
So the right “what to check” list is short. Listen for a damper that sticks. Watch for smoke backing into the room when the fire is going. Notice moisture or staining on the chimney’s exterior. Ask your technician when the flue was last scanned with a camera. If the answer is “never” or “not sure,” that’s the call to make.
For longer service on the chimney itself, our chimney sweep High Point page covers the sweep-and-inspect side, and the pricing on this one follows the same ranges. Between the two, you should be able to price out what you’re likely facing before anyone drives out.
How to Get a Fireplace Services Estimate in High Point
Free estimates work the same way every time. You call, we ask a few questions about the fireplace, the dryer vent, and the chimney, and we book a visit. On the visit we sweep or inspect, run a camera if it’s needed, and hand you a written estimate before any repair work starts. No open-ended labor, no price that changes on the invoice. Our technicians have up to 14 years of experience, they carry professional-grade materials, and they explain the findings in plain terms so you know why a job costs what it does.
The reason this matters in High Point: whether you need a $150 sweep or a $5,800 reliner, the number should come from what’s physically in the flue, not from a menu. If the flue only needs resurfacing, we’ll say so and quote HeatShield. If it needs a liner, we’ll show you the camera footage. Choose the estimate that explains the work, not the one that quotes a number and moves on.
Call Chimney Sweep High Point at (877) 798-3391 for a free estimate. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. We handle the sweep, the repair, and the reline start to finish.
Pricing reflects the High Point market as of 2026. Chimney Sweep High Point offers free estimates – call (877) 798-3391.
What Our Customers Say
"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Renee Padgett"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Brian Bennett"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Priya Patel